Automatic steelbar laying

You can automatically create a steel bar laying for a position and direction in an existing geometry. This can be done by specifying a reinforcement or by taking over the reinforcement from a finite element calculation (BFE-Show).

The command ‘BFE-Show’ reads the required reinforcement from a finite element calculation. These values are used for automatic bar steel laying and mesh selection and for checking the inserted reinforcement. By comparing the inserted reinforcement with the required reinforcement, the missing reinforcement is displayed.

Based on as value

SOF_BT_AUTOMATICBARLAYING

Command	Über as-Wert
Tooltip	Erzeugt automatisch eine Stabstahlverlegung nach vorgegebenen as-Werten
Ribbon	None
Menu	Bewehrung > Autom. Stabstahlverelegung

TOOLTIP Erzeugt automatisch eine Stabstahlverlegung nach vorgegebenen as-Werten

Summary

With the command ‘Automatic bar steel laying’ you can create an automatic bar steel laying for a position and direction in an existing geometry without calculating the FE values.

Based on a FE-Calculation

SOF_BT_AUTOMATICBARLAYINGFROMFEM

Command	Über FEM-Bewehrung
Tooltip	Erzeugt automatisch eine Stabstahlverlegung nach vorhandenen statischen Berechnungen
Ribbon	None
Menu	Bewehrung > Autom. Stabstahlverelegung

TOOLTIP Erzeugt automatisch eine Stabstahlverlegung nach vorhandenen statischen Berechnungen

Summary

With the “Automatic bar steel laying” command from FE, you can create an automatic bar steel laying for a layer in an existing geometry by calculating the As values. It is important that a BFE object was previously inserted with the “BFE-Show” command.

BFE Show

Please accept marketing cookies to watch this video.

Note

In the case of linear laying, the bar lengths shown are taken into account. However, these can deviate from the actual length. In the case of linear laying, it also applies that the bar length shown in the laying is taken into account regardless of the actual leg length! In addition, an overlap length for linear relocations can be entered in the Info / Edit dialog window. This is calculated automatically according to the selected standard. The overlap length is relevant in connection with the “BFE-Show” command. The additional object snap “point” is available at the overlap length for easier construction.

SOF_B_BFESHOW

Command	BFE Show
Tooltip	Vergleicht eingelegte mit erforderlicher Bewehrung. Fehlende Bewehrung wird angezeigt
Ribbon	None
Menu	Bewehrung

TOOLTIP Vergleicht eingelegte mit erforderlicher Bewehrung. Fehlende Bewehrung wird angezeigt

Summary

The ‘BFE-Show’ command is used to check the inserted reinforcement. By comparing the existing reinforcement with the results of the required reinforcement (finite element calculation), the “undercoverage” (missing reinforcement) is displayed.

Optimize meshes / BFE

SOF_B_MATCHMESHBFE

Command	Matten/BFE optimieren
Tooltip	Passt alle Matten eines Mattenfeldes entsprechend dem BFE Objekt an
Ribbon	None
Menu	Bewehrung

TOOLTIP Passt alle Matten eines Mattenfeldes entsprechend dem BFE Objekt an

Summary

Fits all meshes in a mesh field according to the BFE-object.