Member

The Members are defined in the parameters. By entering a name for a component, a new one is automatically created and set. If no members have yet existed in the drawing, the current one is assigned to the existing reinforcement objects. New objects are generally assigned the currently set member. Only laying, VE iron and mats are assigned a member. Extracts from steel bars are not taken into account. It is therefore possible for a position to be relocated to several members. The member can be changed later via Info / Edit or the properties dialog. If relocations with assigned member are inserted in a drawing without member, they lose this information. If memebers already exist in the drawing, the inserted routings keep their information.

Switch on Browsing members

SOF_B_GROUPBROWSEON

Command	Blättern einschalten
Tooltip	Schaltet das Blättern durch alle Bauteile ein. Gilt für Stabstahl und Matten
Ribbon	None
Menu	Bewehrung > Bauteile

TOOLTIP Schaltet das Blättern durch alle Bauteile ein. Gilt für Stabstahl und Matten

Summary

With the command ‘Switch on Browsing members’ you can view each member individually. All members except the one to be considered are switched off. In this way you can leaf through all members and check them. The layer T__KONS can optionally remain on or off.

Switch off Browsing members

SOF_B_GROUPBROWSEOFF

Command	Blättern ausschalten
Tooltip	Schaltet das Blättern durch alle Bauteile aus. Gilt für Stabstahl und Matten
Ribbon	None
Menu	Bewehrung > Bauteile

TOOLTIP Schaltet das Blättern durch alle Bauteile aus. Gilt für Stabstahl und Matten

Summary

After executing the command ‘Switch on Browsing members’, the command ‘Switch off Browsing members’ must be called up so that all membersare shown again.

Rename member

SOF_B_GROUPRENAME

Command	Umbenennen
Tooltip	Umbennen eines Bauteils
Ribbon	None
Menu	Bewehrung > Bauteile

TOOLTIP Umbennen eines Bauteils

Summary

Existing members can be renamed using the ‘Rename member’ command.

Member info

SOF_B_GROUPINFO

Command	Info
Tooltip	Informationen über das aktuelle Bauteil. Gilt für Stabstahl und Matten
Ribbon	None
Menu	Bewehrung > Bauteile

TOOLTIP Informationen über das aktuelle Bauteil. Gilt für Stabstahl und Matten

Summary

The laid steel bars and mats are listed in the defined members.

Assign member

SOF_B_GROUPASSIGN

Command	Zuweisen
Tooltip	Ein Bauteil an Elemente zuweisen
Ribbon	None
Menu	Bewehrung > Bauteile

TOOLTIP Ein Bauteil an Elemente zuweisen

Summary

With this command, laid steel bars and meshes can be assigned to a specific component.