Rebar info 2¶
Scroll through¶
Note
If you are looking for a known position number, you can enter it using the keyboard and confirm with ‘RETURN’. If you want all positions to be visible again, use the Scroll Out command.
Note
If you are looking for a known position number, you can enter it using the keyboard and confirm with ‘RETURN’. If you want all positions to be visible again, use the Scroll Out command.
Command |
Blättern ein |
Tooltip |
Schaltet das Blättern für Stabstahlverlegungen ein |
Ribbon |
None |
Menu |
Bewehrung > Stabstahlinfo |
With this you can look at each position individually. All positions except the rebar mark to be considered are switched off. In this way you can scroll through and check all reinforcement positions. The layer T__KONS can be switched on or off.
Leaf out¶
Command |
Blättern aus |
Tooltip |
Schaltet das Blättern für Stabstahlverlegungen aus |
Ribbon |
None |
Menu |
Bewehrung > Stabstahlinfo |
With this command you can show all positions again after the command “Scroll on”.
Show position¶
Command |
Position einblenden |
Tooltip |
Blendet beliebige Positionen der Stabstahlverlegung ein, die beim Blättern ausgeschalten wurden |
Ribbon |
None |
Menu |
Bewehrung > Stabstahlinfo |
You can use the “Show mark” command to switch on individual rebar marks.
Hide position¶
Command |
Position ausblenden |
Tooltip |
Blendet beliebige Positionen der Stabstahlverlegung aus |
Ribbon |
None |
Menu |
Bewehrung > Stabstahlinfo |
You can use the “Hide mark” command to switch off individual rebar marks. To reactivate all positions that have been switched off, select the “Show mark” command.
Show reinforcement¶
Command |
Bewehrung anzeigen |
Tooltip |
Blendet alle Stäbe der verlegten Bewehrungen in der Ansicht temporär ein. Wird z.B. durch zoomen wieder gelöscht |
Ribbon |
None |
Menu |
Bewehrung > Stabstahlinfo |
The linear routings of straight bars (A1 or 00) are temporarily displayed for information. This enables the laying areas to be checked.